Refresh Addresses - Intel 80C188EC User Manual

REFRESH CONTROL UNIT
The BIU does not queue DRAM refresh requests. If the Refresh Control Unit generates another
request before the BIU handles the present request, the BIU loses the present request. However,
the address associated with the request is not lost. The refresh address changes only after the BIU
runs a refresh bus cycle. If a DRAM refresh cycle is excessively delayed, there is still a chance
that the processor will successfully refresh the corresponding row of cells in the DRAM, retaining
the data.
7.4

REFRESH ADDRESSES

Figure 7-3 shows the physical address generated during a refresh bus cycle. This figure applies
to both the 8-bit and 16-bit data bus microprocessor versions. Refresh address bits RA19:13 come
from the Refresh Base Address Register. (See "Refresh Base Address Register" on page 7-8.)
From Refresh Base
Address Register
RA RA RA RA RA
19 18 17 16
19
A linear-feedback shift counter generates address bits RA12:1 and RA0 is always one. The
counter does not count linearly from 0 through FFFH. However, the counting algorithm cycles
uniquely through all possible 12-bit values. It matters only that each row of DRAM memory cells
is refreshed at a specific interval. The order of the rows is unimportant.
Address bit A0 is fixed at one during all refresh operations. In applications based on a 16-bit data
bus processor, A0 typically selects memory devices placed on the low (even) half of the bus. Ap-
plications based on an 8-bit data bus processor typically use A0 as a true address bit. The DRAM
controller must not route A0 to row address pins on the DRAMs.
7-4
From Refresh Address Counter
RA RA RA RA RA
15 14 13 12 11 10
20-Bit Refresh Address
Figure 7-3. Refresh Address Formation
RA RA RA RA RA RA
9 8 7 6 5 4
Fixed
RA RA RA 1
3 2 1
0
A1266-0A