Connecting The Modem At The Srx240 Services Gateway End; Gateway; Table 34: Port Settings For Configuring The Modem On The Services Gateway - Juniper SRX240 Hardware Manual

SRX240 Services Gateway Hardware Guide

Connecting the Modem at the SRX240 Services Gateway End

64
Before you can connect a dial-up modem to the console port on the SRX240 Services
Gateway, you must configure the modem to accept a call on the first ring and accept
DTR signals. You must also disable flow control on the modem.
NOTE: These instructions use Hayes-compatible modem commands to
configure the modem. If your modem is not Hayes-compatible, refer to the
documentation for your modem and enter the equivalent modem commands.
To configure the modem on the services gateway end:
Connect the modem to a PC or laptop computer.
1.
Power on the modem.
2.
From the PC or laptop computer, start your asynchronous terminal emulation
3.
application (such as Microsoft Windows HyperTerminal), and select the
which the modem is connected (for example,
Configure the port settings as shown in
4.
Table 34: Port Settings for Configuring the Modem on the Services
Gateway End
Port Setting
Bits per second
Data bits
Parity
Stop bits
Flow control
In the HyperTerminal window, enter
5.
For more information on the AT commands, see the following topics:
Initial Configuration for Security Devices
Monitoring and Troubleshooting for Security Devices
An response verifies that the modem can communicate successfully with the
OK
port on the PC or laptop.
Configure the modem to answer a call on the first ring by entering
6.
Configure the modem to accept modem control DTR signals by entering
7.
COM1 ).
Table 34 on page 64.
Value
9600
8
None
1
None
AT .
Copyright © 2015, Juniper Networks, Inc.
port to
COM
COM
.
ATS0=1
.
AT&D1