Flowcontrol Commands; Set Internal Buffering Command; Show Internal Buffering Command; Set Port Flowcontrol Command - Avaya P130 User Manual

FlowControl Commands

Set internal buffering Command

Use the set internal buffering command to set the size (either Maximum
or Minimum) of the Receive (Rx) buffer allocated to each port of the specified
module. This command is meaningless when any port of the module is operating
with flow control ON. You must reset the switch after setting the internal buffering
parameters.
The syntax for this command is:
set internal buffering <mod_num> {max|min}
max
min
Example:
P130-N> set internal buffering 1 max
Done.

Show internal buffering Command

Use the show internal buffering command to show the size options
(Maximum, Minimum, or Medium) of the Receive (Rx) buffer allocated to each port
of the specified module.
The syntax for this command is:
show internal buffering [<mod_num>]
<mod_num>
Example:
P130-N> show internal buffering 1
Module
------
1

Set port flowcontrol Command

See Set port flowcontrol Command on page 74

Show port flowcontrol Command

See Show port flowcontrol Command on page 67.
Avaya P130 User's Guide
Sets the internal receive buffer to its maximum size.
Sets the internal receive buffer to its minimum size (this is the
Default).
Module number
Internal Buffer
---------------
med
Chapter 6 Avaya P130 CLI
81