Comtech EF Data CDM-710G Installation And Operation Manual page 231

CDM-710G High-Speed Satellite Modem
Remote Control
Command Arguments for
Parameter (Instruction Command or
Type Code and Response to
Qualifier)
Rx Gold Code RGS= 6 bytes
Sequence Index
Rx Interface RIE= 2 bytes
Enable
Retrieve next 5 N/A 75 bytes
unread Stored
Events
Rx Pilot On/Off N/A 1 byte
Description of Arguments
Query
Command or Query.
Rx Gold Code Sequence Index:
xxxxxx = Gold Code Sequence index ( 0 to 262141 )
Example: RGS=189063
Command or Query.
Interface Slot Enable/Disable, where:
s=Defines which interface slot (1 or 2)
x=Rx Interface Status, where:
0=Disabled
1=Enabled
Example: RIE =11 (Enables receive interface)
Query Only.
Unit returns the oldest 5 Stored Events which have not yet been read over
the remote control in the form: {CR}Sub-body{CR}Sub-body{CR}Sub-
body{CR}Sub-body{CR}Sub-body, where Sub-body= ABCddmmyyhhmmss:
A being the fault/clear indicator.
F=Fault
C=Clear
I=Info
B being the fault type where:
1=Unit
2=Rx Traffic
3=Tx Traffic
4=Log
C is Fault Code numbers, as in FLT? or Info Code, which is:
0=Power Off
1=Power On
2=Log Cleared
3=Global Config Change
4=Redundancy Config Change
If there are less than 5 events to be retrieved, the remaining positions are
padded with zeros. If there are no new events, the response is RNE*.
QueryOnly .
Rx Pilot On/Off selection, where:
0=Off,
1=On
Example: RPI=0 (which is Pilot Off)
Returns RPI=x if Demodulator unlocked.
This is automatically detected on demod acquisition.
A–41
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
RGS= RGS? RGS=xxxxxx
RGS?
RGS*
RGS#
RIE= RIE?s RIE=sx
RIE?
RIE*
RIE#
RNE? RNE? RNE={CR}ABCddmmyyh
RNE* hmmss{CR}ABCddmmyy
RNE# hhmmss{CR}ABCddmmy
yhhmmss{CR}ABCddmm
yyhhmmss
{CR}ABCddmmyyhhmms
s
N/A RPI? RPI=x
Revision 1
MN-CDM710G