(Config:) Intfc2 Gigabit Ethernet Rx; (Config:) Intfc2 Gigabit Ethernet Man - Comtech EF Data CDM-710G Installation And Operation Manual

CDM-710G High-Speed Satellite Modem
Front Panel Operation
This display is read-only. If Tx: Disabled is displayed, the port is turned off:
Intfc2 Data Rate:
Tx: Disabled
Press or
ENTER
If Intfc2 Tx:
Intfc2 Tx Enable:
Enable Disable
Using the
select Disable to de-activate the transmit side of this interface. Press
(CONFIG:) Intfc2 Gigabit Ethernet
Intfc2 Rx:
Data Enable
Select Data or Enable using the
If Intfc2 Rx:
Intfc2 Data Rate:
Rx:075.000000 Mbps
This display is read-only. If Rx: Disabled is displayed, the port is turned off:
Intfc2 Data Rate:
Rx: Disabled
Press or
ENTER
If Intfc2 Rx:
Intfc1 Rx Enable:
Enable Disable
Using the
select Disable to de-activate the receive side of this interface. Press
(CONFIG:) Intfc2 Gigabit Ethernet
Intfc2 Management IP:
192.168.001.001/30 (
Edit the Gigabit Ethernet Interface Management IP Address and Mask Range. This is the IP address
that can be used for one of two purposes:
•
First, PING can be used with this IP address as a diagnostic tool to ensure the
interface is active and the external cabling in properly connected.
(E)
to return to the previous menu.
CLEAR
Enable is selected:
( E)
arrow keys, select Enable to activate the transmit (Tx) side of this interface, or
( E)
arrow keys, then press
Data is selected:
(E)
(E)
to return to the previous menu.
CLEAR
Enable is selected:
(
arrow keys, select Enable to activate the receive (Rx) side of this interface, or
▲ ▼ E)
Rx
ENTER
E)
Man
6–31
Revision 1
MN-CDM710G
when done.
ENTER
.
when done.
ENTER