Table of Contents
Advertisement
CDM-710G High-Speed Satellite Modem
Preface
depicting actual text displayed on the screen of the unit (RS-232, RS-485, etc.). All other references
in the manual will be shown with the EIA designations.
The user should make special note of the following information and instructions:
IMPORTANT
Electrical Safety
The CDM-710G High-Speed Satellite Modem has been shown to comply with safety standard EN
60950: Safety of Information Technology Equipment, including Electrical Business Machines.
The equipment is rated for operation over the range 100 to 240 VAC. It has a maximum power
consumption of 88 watts, and draws a maximum of 770 mA.
Fuses
FOR CONTINUED OPERATOR SAFETY, ALWAYS REPLACE THE FUSES WITH
THE CORRECT TYPE AND RATING.
CAUTION
The CDM-710G is fitted with two fuses - one each for line and neutral connections. These are
contained within the body of the IEC power inlet connector, behind a small plastic flap.
•
For 115 and 230 volt AC operation, use T2.00A, 20mm fuses.
•
For 48 VDC operation, use T6.25A, 6.3x32mm fuses.
Environmental
The CDM-710G shall not be operated in an environment where the unit is exposed to extremes of
temperature outside the ambient range 0 to 50°C (32° to 122°F), precipitation, condensation, or
humid atmospheres above 95% RH, altitudes (unpressurized) greater than 2000 meters, excessive
dust or vibration, flammable gases, corrosive or explosive atmospheres.
Operation in vehicles or other transportable installations that are equipped to provide a stable
environment is permitted. If such vehicles do not provide a stable environment, safety of the
equipment to EN60950 may not be guaranteed.
Installation
The installation and connection to the line supply must be made in compliance to local or national
wiring codes and regulations.
The CDM-710G is designed for connection to a power system that has separate ground, line and
neutral conductors. The equipment is not designed for connection to power system that has no
direct connection to ground.
The CDM-710G is shipped with a line inlet cable suitable for use in the country of operation. If it
is necessary to replace this cable, ensure the replacement has an equivalent specification.
Examples of acceptable ratings for the cable include HAR, BASEC and HOXXX-X. Examples of
xiv
Revision 1
MN-CDM710G
Advertisement
Table of Contents
