Table of Contents
Advertisement
CDM-710G High-Speed Satellite Modem
Remote Control
Command
Arguments for
Parameter
(Instruction
Command or
Type
Code and
Response to
Qualifier)
Interface
EFI=
2 bytes
Reference
Clock
External
ERF=
1 byte
Reference
Frequency
Rx Es/No
N/A
4 bytes
Enable
ESW=
1 byte, value of
Redundancy
0 or 1
Switch Mode
Firmware
N/A
1 byte
Revisions
Description of Arguments
Query
Command or Query.
s=Defines which interface slot (1 or 2)
x=EXT CLK (Data Rate Accuracy), where:
0 = 1 MHz
1 = 2 MHz
2 = 2.048 MHz
3 = 5 MHz
4 = 10 MHz
5 = 20 MHz
6 = 34.368 MHz
7 = 44.736 MHz
8 = 51.840 MHz
Note: Command valid only with CDI-10-1 G.703 interface
Example: EFI=14 (Selects 10MHz on slot 1)
Command or Query.
External Reference Frequency, where:
0=Internal
1=External 1 MHz
2=External 2 MHz
3=External 5 MHz
4=External 10 MHz
5=External 20 MHz
Example: ERF=0 (External reference not used - uses internal)
Query only.
Unit returns the value of EsNo (when in DVB-S2 mode), between 0 and 16
dB, resolution 0.1 dB.
Returns 99.9 if demod is unlocked.
Example: ESN=12.3 (which is Es/No = 12.3 dB)
For values greater than 22.0 dB, the reply will be: ESN=+022
Command or Query.
Set redundancy mode, where :
0 = Disable
1 = Enable
Example: ESW=1 (Enable redundancy mode)
Query Only.
Query the version information of the system. Where:
i = Bulk Image number (1 or 2)
a = Firmware Image
b = Firmware Revision
c = Firmware Date
Example: FRW?1
EFI=
EFI?
EFI*
EFI#
ERF=
ERF?
ERF*
ERF#
ESN?
ESN*
ESN#
ESW=
ESW?
ESW*
ESW#
FRW?
FRW*
FRW#
A–19
MN-CDM710G
Query
Response to
(Instruction
Response to Query
Command
Code and
Qualifier)
EFI?s
EFI=sx
(see description of
arguments)
ERF?
ERF=x
ESN?
ESN=xxxx
ESW?
ESW=x
FRW?i
FRW={CR}Boot:{CR}a,b,
c{CR}Bulki:{CR}a,b,c{CR
}a,b,c...
Revision 1
Advertisement
Table of Contents
