(Config:) Alarm Mask: Intfc1 (Cdi-60 Hssi Interface Card); (Config:) Alarm Mask: Intfc2 (Cdi-70 Gige Interface Card) - Comtech EF Data CDM-710G Installation And Operation Manual

CDM-710G High-Speed Satellite Modem
Front Panel Operation
If Intfc1 Port1 Tx Alarms:
Buffer Slip Alarm:
Alarm Fault
The default selection is Alarm. Select Alarm, Fault, or Mask using the ◄ ► arrow keys, then
press
ENTER.
If Intfc1 E3T3STS1 Alarms:
Intfc1 Ext-Clk Alarm:
Alarm Fault
The default selection is Alarm. To configure the loss of External Clock as either an Alarm or a
Fault condition or to mask the alarm, select Alarm, Fault, or Mask using the ◄ ► arrow keys,
then press
ENTER
(CONFIG:) Alarm Mask:
Intfc1 HSSI Alarms:
Tx Rx
Select Tx or Rx using the ◄ ► arrow keys, then press
If Intfc1 HSSI Alarms:
Intfc1 Tx Clock Alarm:
Alarm Fault
Select Alarm, Fault, or Mask using the ◄ ► arrow keys, then press
selection is Alarm.
If Intfc1 HSSI Alarms:
Buffer Slip Alarm:
Alarm Fault
Select Alarm, Fault, or Mask using the ◄ ► arrow keys, then press
selection is Alarm.
(CONFIG:) Alarm Mask:
GBEI Tx Cable Alarm:
Alarm Fault
Select Alarm, Fault, or Mask using the ◄ ► arrow keys, then press
selection is Alarm.
Buffer-Slip is selected:
Mask ( E)
Ext-Clk is selected:
Mask ( E)
.
Intfc1 (CDI-60 HSSI Interface Card)
( E)
Tx is selected:
Mask ( E)
Rx is selected:
Mask ( E)
Intfc2 (CDI-70 GigE Interface Card)
Mask ( E)
.
ENTER
6–39
Revision 1
MN-CDM710G
The default
ENTER.
The default
ENTER.
. The default
ENTER