CDM-700 High Speed Satellite Modem
Front Panel Operation
View Negotiation
If Negotiation
sample screens:
Intfc1 GBEI Negotiation
Intfc1 GBEI Negotiation
Intfc1 GBEI Negotiation
6.3.1.7.1 (CONFIG:) Intfc2 (CDI-70 Gigabit Ethernet Interface)
The CDM-700 can be configured with a second CDI-70 Gigabit Ethernet interface board plugged
into interface Slot2 (Intfc2). The menus are identical to what is presented in 6.3.1.7 (CONFIG:)
Intfc1 (CDI-70 Gigabit Ethernet Interface) except that Intfc2, rather than Intfc1, is displayed in
all menus.
6.3.1.8
(CONFIG:) Ref
Frequency Reference
Internal 10 MHz
Select either Internal 10 MHz, or the External 1, 2, 5, 10, 20 MHz using the
The external reference is applied to J7 Ext Ref on the main chassis – not a data interface module.
6.3.1.9
(CONFIG:) Aux
Redundancy Mode:
Ena/Dis
Ena/Dis (Enable/Disable) is used to configure the modem for 1:1 or 1:N operation. The Force
(1:1) selection is only available for use with a 1:1 switch to force switchover.
Note: In VLAN Redundancy, OFFLINE Modem is VLAN UNAWARE.
Select Ena/Dis or Force (1:1) using the ◄ ► arrow keys. Press
If Redundancy Mode:
View is selected, the current negotiation is displayed. See the following
100 HDPX
100 FDPX
1000 FDPX
(
Force(1:1)
Ena/Dis is selected:
E)
(
E)
ENTER.
6–51
Revision 5
MN/CDM700.IOM
arrow keys.
▲ ▼