Serial Interface; Interface Type - IBM 4247 A00 User Manual

5. Press
6. Press
7. To exit from Power On Configuration, press Menu/Enter. Your new value is

Serial Interface

Select this category if your printer is connected to your host computer through an
RS-232C or RS-422A interface. There are several different parameters available:
v Interface Type
v Baud Rate
v Data Bit
v Parity
v Pacing Protocol
v Connection Type
v Buffer Size
v Emulation
v Character Set
v Print Language
v Automatic Carriage Return on Line Feed
v Automatic Line Feed on Carriage Return
v 20 CPI
v NLQ

Interface Type

You can set the system interface to any of the following values:
v Serial No
v RS-232C (default)
v RS-422A
To change or check the Interface Types:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
4. Press
5. Press
6. To exit from Power On Configuration, press Menu/Enter. Your new value is
until the message INTF=xxxxxxxxxxx displays, where xxxxxxxxxxx can
be CX PARALLEL, 1284 BYTE, or 1284 NIBBLE.
until the message NLQ=xxxxxxx displays, where xxxxxxx can be COURIER
or GOTHIC. If you want to select a value other than the one displayed, press
.
stored in NVM.
STARTING UP displays.
displays.
until the message SERIAL INTERFACE displays.
until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
SERIAL NO, RS-232C, or RS-422A. If you want to select a value other than the one
displayed, press or .
stored in NVM.
Chapter 4. Configuring Your Printer
or
91