IBM 4247 A00 User Manual page 154

2. Power off (O) the printer.
3. Attach the Network Print Server to your parallel port.
4. Connect the external power supply to an approved power source.
5. Power on (|) the printer. Ensure forms are loaded in the printer.
6. Press and hold the TEST button until the NETWORK indicator starts to flash,
7. For more information on configuring and connecting your printer to a token-ring
132
4247 Printer Model A00 User's Guide
f. To exit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
Note: With this server attached, the printer is supplied by two power cords.
One is the 4247 Printer power cord and the other is the Network Print
Server power cord.
The NETWORK indicator will flash during power-on and self-test. When the
indicator stops flashing and remains unlighted, the Network Print Server is ready
for use.
then release the button to create a print test sample. This sample lists the
software revision and the basic setup of your Network Print Server.
network, see Network Print Server for Token-Ring Networks Administrator's
Guide (S246-0112) that was shipped with your Network Print Server.