Parity; Pacing Protocol; Connection Type - IBM 4247 A00 User Manual

Parity

You can set parity to any of the following values:
v None (default)
v Odd
v Even
v Mark
v Space
To change or check the Parity:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
until the message SERIAL INTERFACE displays.
4. Press
until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
5. Press
SERIAL NO, RS-232C, or RS-422A.
until the message PARITY=xxxxx displays, where xxxxx can be NONE,
6. Press
ODD, EVEN, MARK, or SPACE. If you want to select a value other than the one
displayed, press or .
7. To exit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.

Pacing Protocol

You can set pacing protocol to either of the following values:
v DTR (default)
v XON/XOFF
To change or check the Pacing Protocol:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
until the message SERIAL INTERFACE displays.
4. Press
until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
5. Press
SERIAL NO, RS-232C, or RS-422A.
until the message PACING=xxxxxxx displays, where xxxxxxx can be DTR
6. Press
or XON/XOFF. If you want to select a value other than the one displayed, press
or .
7. To exit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.

Connection Type

You can set the connection type to either of the following values:
Local (default)
Printer is connected locally to a host computer.
Chapter 4. Configuring Your Printer
93