Set Intercharacter Spacing (Esc Sp); Master Select (Esc !); Cancel Msb Control (Esc #) - IBM 4247 A00 User Manual

The following values are used for NN:
0
1
2
3
4
C
R

Set Intercharacter Spacing (ESC SP)

This control sets the amount of space to be added to the right of each character.
The number of units of space is equal to NN, from 0 to 127. Each unit of space is
1/120th of an inch.

Master Select (ESC !)

This control selects any valid combination of the modes in the table below. To
determine the value of the NN, add together the values of the modes you select
from the table.
Mode
10 CPI
12 CPI
Proportional
Condensed
Emphasized
Double-Strike
Double-Wide
Italic
Underline
This control applies to DP and NLQ. Proportional cannot be condensed and 10 CPI
cannot be combined with 12 CPI. Proportional overrides condensed if both
proportional and condensed are selected. Double-strike is ignored in NLQ.

Cancel MSB Control (ESC #)

228
4247 Printer Model A00 User's Guide
Disable ASF. Ejects any form loaded from bin 1, 2, or 3, and selects Manual
Sheet Feed forms path.
Selects bin 1 if no forms are loaded; otherwise, the next form is loaded
from bin 1 when data is received.
Selects bin 2 if no forms are loaded; otherwise, the next form is loaded
from bin 2 when data is received.
Selects bin 3 if no forms are loaded; otherwise, the next form is loaded
from bin 3 when data is received.
Selects the last bin in use after the Deselect ASF command. A form will be
loaded when data is received.
Selects bin 1 for the first form; then selects bin 2 for all subsequent forms.
Ejects the currently loaded cut-sheet form.
1B 20 NN
1B 21 NN
Decimal
0
1
2
4
8
16
32
64
128
1B 23
Hex
00
01
02
04
08
10
20
40
80