Loading Forms For Rear Pull - IBM 4247 A00 User Manual

4. Press Menu/Enter to save the settings and exit Power On Configuration mode.
5. Press Path until the Rear Pull indicator is blinking and the message

Loading Forms For Rear Pull

The Rear Pull forms path can accept up to 8-part forms with a maximum thickness
of 0.64 mm (0.025 in.).
Figure 39. Stacking Forms for Rear Pull. See page 32 if your printer uses the optional printer
stand.
64
4247 Printer Model A00 User's Guide
This takes a few seconds. Do not press any keys until this completes.
01 END OF FORMS displays.
1. Stack the forms as shown in Figure 39. The top of the input forms stack should
be lower than the bottom of the printer.
2. Press Load/Form Feed to move the printhead to the extreme right.
3. If necessary, press Online to take the printer offline.
4. Lift open the rear tractor door.
5. Open the top cover and the forms guide.
6. Unlock the locking levers on the tractors. Move the right tractor to the extreme
right.
7. Move the left tractor to the tractor alignment mark.