IBM 4247 A00 User Manual page 38

Figure 9. Opening Gear Protector Cover
4. If it is in place, remove the (black protective) cap from the electrical connector
5. Stand facing the front of the printer, holding the forms tractor with the tractor
6. With both hands supporting the tractor shaft, hold down the tractor release lever
Figure 10. Installing Front Tractor
7. Close the front tractor cover.
Your printer may have arrived with a second forms tractor. You will learn about
installing and using this forms tractor after completing "Chapter 1. Printer Setup" on
page 1.
16
4247 Printer Model A00 User's Guide
on the tractor. Save this cap for future storage or shipping of the forms tractor.
doors facing up and the electrical connector tab on the right.
while gently pushing the forms tractor upward until the forms tractor clicks into
place on both sides. Ensure the tractor release levers are locked into place. The
electrical connector tab must be fully seated in the connector and the bottom of
the forms tractor should be even with the base of the printer.