Chapter 2. Considering Other Forms Paths; Choosing Other Forms Paths - IBM 4247 A00 User Manual

Chapter 2. Considering Other Forms Paths

Choosing Other Forms Paths . . . . . . . . . . . . . . . . . . . 33

Choosing a Forms Path for Your Needs . . . . . . . . . . . . . . . 34
Choosing a Forms Path for Special Forms . . . . . . . . . . . . . . 35
Other Considerations for Forms . . . . . . . . . . . . . . . . . . 35
Description of Each Forms Path . . . . . . . . . . . . . . . . . . 36
Choosing Other Forms Paths
IBM recommends you use the Front Push forms path whenever possible. A second
choice is the Rear Push. If the Front Push forms path does not meet your needs,
you can set up and configure the printer for other forms paths. You use a method
similar to that used when you set up the Front Push forms path in "Chapter 1.
Printer Setup" on page 1.
"Chapter 2. Considering Other Forms Paths" helps you choose a forms path other
than the default Front Push forms path. "Chapter 3. Setting Up Another Forms Path"
on page 39 helps you set up that forms path.
You may configure the printer for any one of five forms paths, plus the Manual
Sheet Feed path with the Front Push, the Rear Push, or the Dual Push paths (see
"Preparing Printer for Selected Forms Path" on page 44). Figure 17 on page 34
illustrates the five forms paths and the Manual Sheet Feed.
Each forms path is shown with the necessary tractors installed, and where the
forms input and output stacks should be located.
Notes:
1. The forms tractors are interchangeable between push and pull forms paths, and
2. The paper bail is installed for four of the five forms paths; it must be removed
3. The Manual Sheet Feed can be used with three of the five forms paths.
4. The adjustable edge of each pin feed assembly must be set to properly guide
5. IBM recommends you test the performance in the printer of any forms you
© Copyright IBM Corp. 1995, 1998
Front Push Forms Path . . . . . . . . . . . . . . . . . . . . 36
Rear Push Forms Path
Dual Push Forms Paths . . . . . . . . . . . . . . . . . . . . 36
Rear Pull Forms Path . . . . . . . . . . . . . . . . . . . . . 37
Push Pull Forms Path . . . . . . . . . . . . . . . . . . . . . 37
Manual Sheet Feed . . . . . . . . . . . . . . . . . . . . . . 37
front and rear forms paths.
for the Rear Pull forms path.
the forms in that forms path.
intend to use.
. . . . . . . . . . . . . . . . . . . . 36
33