IBM 4247 A00 User Manual page 43

7. Move the forms supports to be approximately equidistant between each other
and the tractors.
8. Lift the inner edge of each tractor to open the tractor doors.
9. Place the left edge of the form on the left tractor pins so that the form engages
about three left tractor pins. Close the left tractor door.
10. Move the right tractor to the left and under the forms until the holes along the
right edge of the form engage the same number of pins on the right tractor.
Ensure that the right edge of the forms is under the forms jam sensor. Close
the right tractor door.
11. If necessary, slide the right tractor either left or right to remove any slack in the
form, ensuring that the left and right tractor pins are centered in the holes of
the forms. Hold the right tractor in place. Pull the locking lever forward to lock
the right tractor.
21
Chapter 1. Printer Setup