Another Path; Additional Entry Point To Power On Configuration Menu - IBM 4247 A00 User Manual

3. Press
4. Press
5. To exit from Program Configuration, press

Another Path

You can set this category to either one of the following values:
No (default)
Yes
To change or check the Another Paper Path value:
1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press
3. To exit from Program Configuration, press
Additional Entry Point to Power On Configuration Menu
Note: You cannot access the Pull category or the Forms Jam category from this
You can enter the Power On Configuration menu without powering off and powering
on the printer by using the Program Configuration menu. Available values for this
category are:
No (default)
Yes
To enter the Power On Configuration menu from the Program Configuration menu:
1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press
3. To exit from Program Configuration, press
until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6
LPI, 8 LPI, 12 LPI, 3L/30MM, 4L/30MM, 6L/30MM, 8L/30MM, or 12L/30MM.
until the message RESTORE MFG=xxx displays, where xxx can be NO or
YES. If you want to select a value other than the one displayed, press
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
Does not allow you to select another default forms path to
configure.
Lets you return to the Paper Path category in the Program
Configuration menu to configure another default forms path.
until the message ANOTHER PATH=xxx displays, where xxx can be NO or
YES. If you want to select a value other than the one displayed, press
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
entry point. You must use the method outlined in "Power On Configuration"
on page 82.
Does not allow you to return to the Power On Configuration menu.
Allows you to return to the Power On Configuration menu. If you
or , you will return to the start of the menu, PRINT OUT=NO.
press
Entering the Power On Configuration menu through the Program
Configuration menu does not allow you to access the PULL or JAM
SENSORS categories.
until the message CONFIG MENU=xxx displays, where xxx can be NO or
YES. If you want to select a value other than the one displayed, press
displays. If you want to exit without saving the new value, press Menu/Enter.
until the message STORE=QUIT
to select either STORE=SAVE (new
or
until the message STORE=QUIT
to select either STORE=SAVE (new
or
until the message STORE=QUIT
Chapter 4. Configuring Your Printer
or .
or .
or .
119