Adjusting Tear-Off Position - IBM 4247 A00 User Manual

4. Open the acoustic cover, grasp one side of the form, pull it toward you, and
Figure 13. Tear-Off Location. Shown With 11-Inch Long Forms
5. Close the acoustic cover.

Adjusting Tear-off Position

If, after checking the tear-off position, the perforation does not align with the top
cover tear line or if the tear is not clean, adjust the tear-off position.
1. Press Menu/Enter and PRINT OUT=NO displays.
2. Press
3. Press
4. If your printer uses the Rear Push forms path, press
To save your change:
1. Press Menu/Enter and STORE=QUIT displays.
26
4247 Printer Model A00 User's Guide
break the perforation against the serrated edge of the top cover.
The perforation should align with the top cover tear line, and the tear should be
clean.
and TEAR POS. ADJUST displays.
and FRONT PATH=XXX displays. To adjust the tear-off position higher,
press , increasing XXX. To adjust the tear-off position lower, press ,
decreasing XXX.
displays. To adjust the tear-off position higher, press , increasing XXX. To
adjust the tear-off position lower, press , decreasing XXX.
and REAR PATH=XXX