IBM 4247 A00 User Manual page 160

Attention: In the next step, if you cannot easily move the printhead, do not force
it.
10. Cancel the print job at your computer.
11. To clear buffered print data (buffered data is indicated by a blinking Online
12. Reload forms. See "Chapter 1. Printer Setup" on page 1 or "Chapter 3. Setting
13. Press Online to make the printer ready .
14. Resend your print job.
138
4247 Printer Model A00 User's Guide
1. If the printer is powered on (|), and the Online indicator is lighted, press
Online to make the printer not ready .
2. Open the top cover.
3. Tear off the forms at a perforation ahead of where they enter the printer.
4. Open the tractor doors and remove the forms from the tractors.
5. Remove the ribbon cartridge. See "Removing Ribbon Cartridge" on page 133.
6. Move the printhead to the far right.
7. Remove the jammed forms by pulling them in the direction of printing. If this
clears the jam, go to step 9. If the jam still exists, remove the paper bail. Do
not reinstall the ribbon cartridge or close the forms guide or the top cover until
you have cleared the jam. See "Removing Paper Bail" on page 48.
8. Remove jammed forms by pulling in the direction of printing.
9. Reinstall the paper bail and the ribbon cartridge, and close the forms guide
and the top cover. See "Installing Paper Bail" on page 48.
indicator), press Menu/Enter and then press Online. The message 99 RESET
momentarily displays.
Up Another Forms Path" on page 39.