Removing Paper Bail
1. Open the top cover and the forms guide.
2. Remove the ribbon cartridge. See "Removing Ribbon Cartridge" on page 133.
3. Move the printhead to the far right.
4. Grasp the paper bail and rotate it toward the front of the printer until it snaps
Figure 24. Rotating the Paper Bail
5. Using care not to damage the thin plastic strip on the paper bail, lift the paper
Figure 25. Removing the Paper Bail
6. Install the ribbon cartridge. See "Installing Ribbon Cartridge" on page 17.
7. Close the forms guide and the top cover.
8. Store the paper bail. You may need to reinstall the paper bail if you change the
Installing Paper Bail
48
4247 Printer Model A00 User's Guide
loose. Some force is required.
bail up and out of the printer.
forms path.
1. Press Online to take the printer offline.
2. Open the top cover and forms guide.
3. Remove the ribbon. (See "Removing Ribbon Cartridge" on page 133.)
4. Move the printhead to the far right.
5. Hold the paper bail with the plastic strip toward you. Rotate the paper bail so
the plastic strip is pointing down.