Setting Up And Configuring Front Push Forms Path - IBM 4247 A00 User Manual

Table 11 directs you to information about the forms path of your choice.
Table 11. Information About Your Selected Forms Path
Setting Up and Configuring Front Push Forms Path
Figure 30 shows the Front Push forms path with Manual Sheet Feed.
Figure 30. Front Push and Manual Sheet Feed Forms Paths
The Front Push tractor is used for the Dual Push and the Push Pull forms paths, as
well as the Front Push forms path. The printer is shipped to you with the Front
Push forms path set as the default.
1. Ensure the correct settings are made for the Front Push forms path. Refer to
2. Perform the steps in "Installing Front Push Tractor" on page 15.
3. Configure the printer for the Front Push forms path by following these steps:
52
4247 Printer Model A00 User's Guide
Forms Path
Front Push "Setting Up and Configuring Front Push Forms Path"
Rear Push "Setting Up Rear Push Forms Path" on page 53
Dual Push "Setting Up Dual Push Forms Paths" on page 57
Rear Pull "Setting Up Rear Pull Forms Path" on page 60
Push Pull "Setting Up Push Pull Forms Path" on page 70
the tables in "Summarizing Forms Path Set Up" on page 39.
a. Power off (O) the printer.
b. Enter Power On Configuration mode. To do this, press and continue to hold
Menu/Enter while powering on (|) the printer, until (1) the message STARTING
UP appears, (2) the boxes on the operator panel display are solidly filled in,
and (3) the printhead stops. This takes about fifteen seconds. Do not
release this key or press any other keys until this completes.
c. Release Menu/Enter and the message PRINT OUT=NO displays.
and the message PULL=xxxxxxxxx displays, where xxxxxxxxx can be
d. Press
NO, YES, or PUSH+PULL. If xxxxxxxxx is not NO, press
displayed.
Where to Find Your Next Task
or
until NO is