Preparing Dual Push Forms Paths - IBM 4247 A00 User Manual

Figure 36. Dual Push Forms Paths with Manual Sheet Feed
Ensure the correct settings are made for the Dual Push forms path. Refer to the
tables in "Summarizing Forms Path Set Up" on page 39.

Preparing Dual Push Forms Paths

Because this forms path configuration lets you alternate (either manually or
automatically) between the Front Push and Rear Push forms paths, you will load
forms into both forms paths.
1. Stack the forms as shown in Figure 37. The top of the input forms stack should
Figure 37. Stacking Forms for Dual Push. See page 32 if your printer uses the optional
printer stand.
2. If the Front Push forms path is not setup, go to "Setting Up and Configuring
3. Park the forms in the Front Push forms path (see "Parking Continuous Forms"
4. If the Rear Push forms path is not setup, go to "Setting Up Rear Push Forms
5. Park the forms in the Rear Push forms path (see "Parking Continuous Forms"
58
4247 Printer Model A00 User's Guide
be lower than the bottom of the printer.
Front Push Forms Path" on page 52 and set up the Front Push forms path, and
then return here to step 3.
on page 29), and then return here to step 4.
Path" on page 53 and set up the Rear Push forms path. Return here to step 5.
on page 29). Return here to "Configuring Printer for Linking Dual Push" on
page 59.