Setting Up Manual Sheet Feed Path - IBM 4247 A00 User Manual

For additional information, see "Parking One Continuous Form and Loading Another
(Dual Push)" on page 59.

Setting Up Manual Sheet Feed Path

The 4247 Printer provides the ability to print on either single-part or multiple-part,
cut-sheet forms using the Manual Sheet Feed forms path. Manual Sheet Feed can
be used with the Front Push, the Rear Push, and the Dual Push forms paths. See
Figure 18 on page 41 for a depiction of the various paths.
The Manual Sheet Feed also allows you to overlay a single sheet on top of
continuous forms from another forms path, if your total page count does not exceed
8 parts. See "Choosing a Forms Path for Special Forms" on page 35 for limitations.
Setup the Manual Sheet Feed as follows:
1. Insert your thumb into the center opening and pull down to open the Manual
2. Press Path until the Manual Sheet Feed indicator is blinking and the message
3. Move the left cut-sheet paper guide to the left alignment mark. Move the right
30
4247 Printer Model A00 User's Guide
Sheet Feed tray.
06 MANUAL FEED displays.
cut-sheet paper guide to the extreme right. You will not use the right cut-sheet
paper guide on this printer model.