Installing Rear Pull Tractor - IBM 4247 A00 User Manual

Figure 38. Rear Pull Forms Path
Ensure the correct settings are made for the Rear Pull forms path. Refer to the
tables in "Summarizing Forms Path Set Up" on page 39.
Additionally, you will need to perform the following tasks:

1. "Installing Rear Pull Tractor"

2. "Configuring Forms Path for Rear Pull" on page 63
3. "Loading Forms For Rear Pull" on page 64

Installing Rear Pull Tractor

Install the forms tractor in the Rear Pull forms path as follows (see Figure 38):
1. Power off (O) the printer.
2. Open the top cover and the forms guide.
3. Stand facing the front of the printer. Hold the forms tractor with the tractor doors
toward you and the electrical connector tab on the left.
61
Chapter 3. Setting Up Another Forms Path