Line Spacing Lock; Page Length; Top Of Form - IBM 4247 A00 User Manual

Line Spacing Lock

You can set this value to:
No (default)
Yes
To change or check the Line Spacing Lock value:
1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press
3. Press
4. Press
5. To exit from Program Configuration, press

Page Length

You can set the page length for continuous forms to a defined number of lines (1 to
660), or for cut-sheet paper to any of the standard formats (Letter, Legal, A2, A3,
A4, or A5). To compute the page length, multiply the line spacing value by the
physical length of the page. The default value is 66 lines for continuous forms and
LTR (Letter) for cut-sheet paper.
To change or check the Page Length value:
1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press
3. Press
4. Press
5. To exit from Program Configuration, press

Top of Form

Note: You can find similar information in "Vertical" on page 112.
The top of form is where you want your first line of printing to start on a page. You
can adjust the top-of-form position from 0 to 660 units (where each unit is 4.23 mm
[1/6 in.]). The default value is 0.
To change or check the Top of Form value:
114
4247 Printer Model A00 User's Guide
The host can override the vertical spacing value (lines per inch or
lines per 30 mm).
The host cannot override the vertical spacing value (lines per inch
or lines per 30 mm) that was set through the operator panel.
until the message FORM SETTING displays.
until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6
LPI, 8 LPI, 12 LPI, 3L/30MM, 4L/30MM, 6L/30MM, 8L/30MM, or 12L/30MM.
until the message LINE SP LOCK=xxx displays, where xxx can be NO or
YES. If you want to select a value other than the one displayed, press
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
until the message FORM SETTING displays.
until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6
LPI, 8 LPI, 12 LPI, 3L/30MM, 4L/30MM, 6L/30MM, 8L/30MM, or 12L/30MM.
until the message PAGE LENGTH=xxx displays, where xxx can be 1 to 66O,
A5, A4, A3, A2, LGL, or LTR. If you want to select a value other than the one
displayed, press or .
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
until the message STORE=QUIT
to select either STORE=SAVE (new
or
until the message STORE=QUIT
to select either STORE=SAVE (new
or
or .