Data Bits; Buffer Size; Emulation - IBM 4247 A00 User Manual

7. To exit from Power On Configuration, press Menu/Enter. Your new value is

Data Bits

You can set the data bit to either of the following values:
v 8 (default)
v 7
To change or check the Data Bits:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
4. Press
5. Press
6. Press
7. To exit from Power On Configuration, press Menu/Enter. Your new value is

Buffer Size

You can set the buffer to one of the following values:
v 256
v 2K
v 12K
v 32K (default)
v 64K
To change or check the Buffer Size:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
4. Press
5. Press
6. Press
7. To exit from Power On Configuration, press Menu/Enter. Your new value is

Emulation

You can set the emulation type to any of the following values:
v Native 4247 (default)
86
4247 Printer Model A00 User's Guide
stored in NVM.
STARTING UP displays.
displays.
until the message PARALLEL INTF displays.
until the message INTF=xxxxxxxxxxx displays, where xxxxxxxxxxx can
be CX PARALLEL, 1284 BYTE, or 1284 NIBBLE.
until the message DATA BITS=x displays, where x can be 8 or 7. If you
want to select a value other than the one displayed, press
stored in NVM.
STARTING UP displays.
displays.
until the message PARALLEL INTF displays.
until the message INTF=xxxxxxxxxxx displays, where xxxxxxxxxxx can
be CX PARALLEL, 1284 BYTE, or 1284 NIBBLE.
until the message BUFFER=xxx displays, where xxx can be 256, 2K, 12K,
32K, or 64K. If you want to select a value other than the one displayed, press
or .
stored in NVM.
or .