IBM 4247 A00 User Manual page 32

Figure 5. Four Function Keys with Two Functions Each
v The , the , the , and the
mode or Program Configuration mode to allow menu scrolling. See "Chapter 4.
Configuring Your Printer" on page 79 for configuration information.
Table 2. Operator Panel Function Keys
10
4247 Printer Model A00 User's Guide
Function Key
Condition 1 If forms are not present in the current path and the
printer is in a wait condition ( not ready ), press Path to select a
different forms paths.
Condition 2 If forms are present and the printer is in a wait
condition ( not ready ), tear off (at the tear bar) any continuous forms
that have been printed, and press Park to park the continuous
forms (or eject a single sheet, if loaded). The printer then enters an
end-of-forms (EOF) condition. You now can press Path to select the
different path modes according to the forms path configurations
selected in the Power On Configuration menu.
If the printer is ready or a wait condition exists, press Tear to:
v Move the forms up to the tear line for tearing (see "Tearing Off
Forms" on page 24).
v Move a form backward to its initial position [after a 10 second
(approximate) timeout occurs].
Reduces the printing noise level by two or three decibels; however,
the printer runs at half speed and throughput is reduced by one
half.
keys are active only during Power On Configuration
Description