Configure Security Profiles For Advanced Profile Groups - NETGEAR ProSafe WC7520 Reference Manual

Table 16. Network authentication and data encryption settings (continued)
Network authentication
selection
WPA-PSK & WPA2-PSK
Note: Use this option if
there are both WPA-PSK
and WPA2-PSK clients in
the network.

Configure Security Profiles for Advanced Profile Groups

The advanced Profile Group screen lets you create up to 8 profile groups. For each profile
group you can create and configure up to 8 security profiles per wireless radio (8 profiles for
a single-band access point; 16 profiles for a dual-band access point). Separate profiles are
applied to 802.11b/bg/ng-mode and 802.11a/na-mode radios.
By default, all access points are assigned to the basic profile group. After you have created
advanced profile groups, you can use the WLAN Network screen to reassign access points to
any of these advanced profile groups (see
WLAN on page 82).

To add a profile group, configure a new profile, and then add another profile:
1. Select Configuration > Profile > Advanced > Radio. The Profile Groups screen
displays:
Figure 38.
ProSafe 20-AP Wireless Controller WC7520
Data encryption Configuration steps
options
AES To configure WPA-PSK & WPA2-PSK authentication, type a
passphrase of at least 8 characters in the WPA Passphrase
TKIP + AES
(Network Key) field.
Note: The Data Encryption drop-down list displays TKIP + AES,
which is the only available option. Both TKIP and AES are
supported.
Manage Basic and Advanced Profile Groups in the
Managing Security Profiles and Profile Groups
79
Click + to add another profile group.