NETGEAR ProSafe WC7520 Reference Manual page 45

3. Specify the WLAN requirements for the floor as explained in the following table:
Table 5. Floor WLAN requirements
Setting
Access Point Model Specify the access point model that you will use on the floor by selecting the
Frequency Band
Signal Quality
Client Per Radio
Total Clients
4. Click Estimate to view the number of access points required for the settings that you
entered. The number of access points displays in a pop-up window. After you have closed
the pop-up window, the Estimated Access Points row is added to the Planning Buildings
screen.
5. Click View Map to view and optimize the suggested approximate access point locations for
the settings that you entered:
Figure 17.
ProSafe 20-AP Wireless Controller WC7520
Description
WNDAP 350, WNAP 210, WNAP 320, or WNDAP 360 radio button. (The
WNDAP 360 button does not show in the previous figure.)
Select one of the following radio buttons to specify the frequency band that the access
points will function in:
• 802.11b/bg/ng
• 802.11a/na
Specify the required signal quality by moving the slider or by entering a percentage in
the field to the right of the slider. The minimum signal quality is 25 percent; the
maximum is 100 percent.
Specify the expected maximum number of clients per access point by moving the
slider or by entering a number in the field to the right of the slider. The maximum
number of clients that you can configure per access point is 64.
Specify the expected total number of clients on the floor by moving the slider or by
entering a number in the field to the right of the slider. The maximum number of total
clients that you can configure on the floor is 1024.
RF Planning
45