NETGEAR ProSafe WC7520 Reference Manual page 61

Figure 29.
2. Configure the settings as explained in the following table:
Table 10. IP and management VLAN settings
Setting
IP Settings section
IP Address
IP Subnet Mask
Default Gateway
Primary DNS Server
Secondary DNS Server Enter the IP address of the secondary DNS that you want to use.
WINS Server
Management VLAN Settings section
Management VLAN
Untagged VLAN
3. Click Apply to save your settings.
ProSafe 20-AP Wireless Controller WC7520
Description
Enter the IP address of the wireless controller. The default IP address is
192.168.0.250. To change it, enter an available IP address from the address
range used on your LAN.
Enter the subnet mask value used on your LAN. The default value is
255.255.255.0.
Enter the IP address of the gateway for your LAN.
Enter the IP address of the primary Domain Name Server (DNS) that you want to
use.
Enter the IP address of the Windows Internet Name Service (WINS) that you want
to use.
Enter the management VLAN. For information, see
following this table.
Select this check box if the configured VLAN is untagged. For information, see
Untagged VLANs on this page.
Configuring Network Settings
61
Management VLANs