NETGEAR ProSafe WC7520 Reference Manual page 39

Provisioning the Wireless Controller
Step Configuration
1. Configure the basic system settings:
1. Configure the country code of operation.
2. Configure the IP address of wireless controller.
3. Verify that VLAN 1 is set as the management VLAN and is
marked as untagged, which is the default setting.
2. Configure the following profiles, and configure network
authentication and data encryption for these profiles:
1. A profile with SSID 1 and VLAN 10.
2. A profile with SSID 2 and VLAN 20.
3. A profile with SSID 2 and VLAN 30.
4. A profile with SSID 3 and VLAN 40.
3. Configure the following profile groups:
1. A profile group with the name Building 1, to which you add the
following profiles:
- The profile with SSID 1 and VLAN 10
- The profile with SSID 2 and VLAN 20
- The profile with SSID 2 and VLAN 30
2. A profile group with the name Building 2, to which you add the
following profiles:
- The profile with SSID 1 and VLAN 10
- The profile with SSID 2 and VLAN 30
- The profile with SSID 3 and VLAN 40
4. Deploy the access points and connect them to PoE switches.
5. Wait until the access points are up and running, run the Discovery
Wizard, specify the network layout by selecting the Same L2
network radio button, and select the access points that you want to
be managed by the wireless controller.
7. Assign the access points to the access point profile groups (also
referred to as WLAN groups).
ProSafe 20-AP Wireless Controller WC7520
System Planning and Deployment Scenarios
39
Web management interface path
Configuration > System > General
Configuration > System > IP/VLAN
Configuration > Profile > Basic
Configuration > Profile > Advanced
Access Point > Discovery Wizard
Configuration > WLAN Network