Run The Discovery Wizard - NETGEAR ProSafe WC7520 Reference Manual
20-ap wireless controller
Hide thumbs
Also See for ProSafe WC7520:
- Reference manual (162 pages) ,
- Datasheet (6 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
In addition, for the auto discovery process to work across Layer 3 networks, enable either
one of the following options:
Multicast routing for IP address 254.0.100.250 between the wireless controller and the
•
access points.
•
DHCP option 43 (vendor-specific information) on the DHCP server. Specify the wireless
controller's IP address to allow the access points to receive the wireless controller's IP
address and the DHCP server to assign IP addresses to the access points.
The DHCP server on the wireless controller automatically enables DHCP option 43 with
its own IP address.
Run the Discovery Wizard
The Discovery wizard finds access points that are not yet on the managed access point list.
To run the Discovery Wizard:
1.
Select Access Point > Discovery Wizard. The Discovery Wizard screen displays:
Figure 20.
2.
Select the radio button to specify the state of the access points that you want to discover:
•
Factory default state. The access points have not been configured.
•
Installed and working in Standalone Mode. The access points have been
configured or deployed, but they are not yet on the Managed AP List.
•
I am not sure. Select this radio button to display documentation.
3.
Click Next. The next Discovery Wizard screen displays:
ProSafe 20-AP Wireless Controller WC7520
Access Point Discovery and Management
50
Advertisement
Table of Contents
