NETGEAR ProSafe WC7520 Reference Manual page 169

Table 46. Controller summary information (continued)
Item
WPA
WPA2
Rogue Access Points section
Rogue AP current
Rogue AP count 24hrs
Network Info section
This information is self-explanatory.
Redundancy Status section
This information displays only if wireless controller redundancy is configured.
Controller Mode
Redundancy State
Secondary Status
Sync Status
Primary IP Address
Secondary IP Address
Virtual IP
Monitoring the Wireless Network and Components
ProSafe 20-AP Wireless Controller WC7520
Description
The number of wireless clients that are connected to managed access points using
security profiles configured with WPA.
The number of wireless clients that are connected to managed access points using
security profiles configured with WPA2.
The total number of unique rogue and unmanaged neighboring access points that
are detected now by the wireless controller.
The total number of unique rogue and unmanaged neighboring access points that
were detected over the last 24 hours by the wireless controller.
The redundancy mode in which the wireless controller functions (Primary or
Secondary).
The state of the redundancy group (Active, Down, Sync in progress, Firmware
mismatch).
The status of the secondary controller in the redundancy group (Reachable or Not
reachable).
The synchronization status between the wireless controllers in the redundancy
group (In Sync or Not in Sync).
The IP address of the primary controller in the redundancy group.
The IP address of the secondary controller in the redundancy group.
The common IP address that is used by both the primary and secondary controller
in the redundancy group and that always is owned by the active controller.
169