Edit And Remove Profiles From The Basic Profile Group - NETGEAR ProSafe WC7520 Reference Manual

Table 15. Basic security profile definition settings (continued)
Setting
Open System, Shared
Key, WPA-PSK,
WPA2-PSK, and
WPA-PSK & WPA2-PSK
(continued)
WPA with Radius,
WPA2 with RAdius, and
WPA & WPA2 with Radius
Wireless QoS section
Wi-Fi Multimedia (WMM)
WMM Powersave
6. Click Apply to save your settings.

Edit and Remove Profiles from the Basic Profile Group


To edit an existing profile:
1. On the Basic Profile screen, click a tab to select a profile.
2. Click a tab to select a radio.
3. Change the settings as explained in the previous table and the following table.
4. Click Apply to save your settings.

To remove an existing profile:
• On the Basic Profile screen, click a tab to select a profile.
• Click a tab to select a radio.
5. Click Delete, and then confirm that you want to delete the profile.
ProSafe 20-AP Wireless Controller WC7520
Description
Captive Portal Select this check box if you want to enable the captive portal.
For more information, see
page 119.
Note:
network authentication uses an external RADIUS server. That
is, if you configure an external RADIUS server with WPA,
WPA2, or WPA & WPA2 (or if you use legacy 802.1X), the
Captive Portal check box is not shown onscreen.
Authentication Select one of the following radio buttons:
Server
• Local. Use the local authentication server.
• External. Use an external authentication server. Select an
external authentication server from the Authentication Server
drop-down list.
Note:
and external authentication servers, see
Authentication Servers and Authentication Server Groups
page 115.
To enable Wi-Fi Multimedia (WMM), select the Enable radio button, which is
the default setting. Select the Disable button to disable the feature. For more
information, see Configure QoS for Profile Groups
The WMM Powersave feature saves power for battery-powered equipment by
increasing the efficiency and flexibility of data transmission. To enable this
feature, select the Enable radio button, which is the default setting. Select the
Disable button to disable the feature.
Managing Security Profiles and Profile Groups
75
Configure Captive Portal Settings
You cannot configure captive portal authentication if the
For information about setting up and enabling internal
on
Manage
on
on page 99.