NETGEAR ProSafe WC7520 Reference Manual page 54

ProSafe 20-AP Wireless Controller WC7520
The Managed AP List shows the following entries for each access point that you added to
the list:
Table 6. Managed AP list information
Item Description
IP The IP address of the access point.
MAC The MAC address of the access point.
Model The model of the access point.
Name The name of the access point.
Status • Authentication in progress
• Applying configurations
• Firmware upgrade
• AP is rebooting
• Connecting
• Connected
• Not connected
Note: Make sure that there is a DHCP server enabled in the network; otherwise, the
managed access points remain in the Connecting state and do not enter the Connected
state.
Group Name The default group is basic.
Capability The wireless modes that are supported by the access point.
Note: Capability information lets you determine which access points are 802.11n mode
capable but function in 802.11g mode.
2.4ghz Mode The access point's wireless modes that function in the 2.4-GHz band.
5ghz Mode The access point's wireless modes that function in the 5-GHz band.
Note: To restore a managed access point to its original firmware and use it
once again as a standalone access point, remove the access point
from the Managed AP List. Log in to the access point's web
management interface, upgrade the firmware to the standalone AP
firmware version, and then reboot the access point.
Access Point Discovery and Management
54