NETGEAR ProSafe WC7520 Reference Manual page 63


To add a DHCP server and configure its settings:
1. Select Configuration > System > DHCP. The DHCP Settings screen displays. The
following figure shows part of the DHCP Settings screen:
Figure 30.
The DHCP Server List shows the DHCP servers that are already configured on the
wireless controller.
2. Click Add. The Add DHCP Server pop-up window displays:
Figure 31.
3. Configure the settings as explained in the following table:
Table 11. DHCP settings
Setting
Enabled
Use VLAN Interface
VLAN
ProSafe 20-AP Wireless Controller WC7520
Description
Select this check box to enable the DHCP server. When the check box is cleared,
the DHCP server is disabled.
Select this check box to allow the DHCP server to function with multiple VLANs.
Enter the DHCP server VLAN ID. The range is between 1 and 4094. The DHCP
server will service this VLAN.
Configuring Network Settings
63