Hardware Features; Front Panel Ports And Leds - NETGEAR ProSafe WC7520 Reference Manual

Hardware Features

The front panel ports and LEDs, rear panel components, and bottom label of the wireless
controller are described in this section.

Front Panel Ports and LEDs

The following figure shows the front panel ports and status LEDs of the wireless controller.
Figure 1.
From left to right, the wireless controller's front panel shows the following ports and LEDs:
• Power LED
• Test LED
• USB port for external storage, for example for more floor heat maps and extended
statistics history
• Four 10/100/1000 Mbps LAN Ethernet ports with RJ-45 connectors, left LEDs, and right
LEDs. All Ethernet ports provide switched N-way, automatic speed negotiating, auto
MDI/MDIX technology.
Note: The four ports of the wireless controller function as a single switch.
The function of each LED is described in the following table:
Table 1. LED functions
LED Status
Power LED On
Off
Test LED On
Off
Blinking
ProSafe 20-AP Wireless Controller WC7520
Description
The green Power LED should be lit when the wireless controller is on.
If the power LED is not lit when the wireless controller is on, check the
connections and check to see if the power outlet is controlled by a wall switch
that is turned off (see Power LED Not On
The wireless controller is initializing. After approximately 2 minutes, when the
wireless controller has completed its initialization, the Test LED turns off. If the
Test LED remains on, the initialization has failed (see
on page 179).
The wireless controller has completed its initialization successfully. The Test
LED should be off during normal operation.
Firmware is being upgraded.
Introduction and Overview
12
on page 178).
Test LED Never Turns Off