View The Wireless Controller Summary Screen - NETGEAR ProSafe WC7520 Reference Manual

View the Wireless Controller Summary Screen

Figure 100.
The following table explains the fields of the Network Status, Wireless Clients, Rogue Access
Points, Network Info, and Redundancy Status tables on the Controller Summary screen:
Table 46. Controller summary information
Item
Network Status section
For each access point and client, the following information displays:
Total Up
Down
Alarms Critical
Major
Wireless Clients section
For each wireless client, the following information displays:
Open
WEP
Monitoring the Wireless Network and Components
ProSafe 20-AP Wireless Controller WC7520
Description
The total number of managed devices that are running correctly.
The total number of managed devices that cannot be pinged.
The wireless controller can ping these managed devices, but either cannot log in or
has detected that these device are different from the ones that were configured.
The number of managed devices for which the configuration differs from the one
that is set on the wireless controller. This situation occurs most likely because the
device runs outdated firmware or the wireless controller changed the configuration
while the device was down or offline.
The number of wireless clients that are connected to managed access points using
security profiles configured with open mode.
The number of wireless clients that are connected to managed access points using
security profiles configured with WEP.
168