NETGEAR ProSafe WC7520 Reference Manual page 83

Figure 41.
The displayed settings are explained in the following table:
Table 18. WLAN group assignments
Setting
IP
MAC
Model
Name
Building
Floor
Status
2. To assign an access point to a profile group, select the profile group name from the Group
Name drop-down list. For information about adding and specifying groups, see the previous
section.
3. Click Apply to save your settings.
ProSafe 20-AP Wireless Controller WC7520
Description
The IP address of the access point.
The MAC address of the access point.
The model of the access point.
The name that you specified for the access point.
The building in which the access point is located. For more information, see
and Edit Buildings and Floors
Information on page 55.
The floor on which the access point is located. For more information, see
Edit Buildings and Floors on page 41 and
on page 55.
The access point connectivity status.
• Connected. This indicates normal operation.
• Not Connected. The wireless controller cannot communicate with the access point
at the configured IP address.
The wireless controller tries to log in to managed access points each minute. If the
error is temporary, the status automatically changes to connected. If the error is
prolonged, verify the access point's IP address and network connectivity.
Managing Security Profiles and Profile Groups
83
on page 41 and Edit and Remove Access Point
Edit and Remove Access Point Information
Define
Define and