Before Making Copies
3.8
Power Switch and Default Settings
Turning the Copier On and Off
To turn the copier on
§
Set the power switch to "I".
When the copier is turned on, the
indicator on the [Start] key lights up in
orange. A screen indicating that the
machine is starting up appears.
After a few seconds, the message "Now
warming-up. Ready to scan." appears
on the touch panel. When the indicator
on the [Start] key lights up in green, a
job can be queued.
To turn the copier off
1
Touch [Job Log] to check that no jobs are queued.
2
If any copies or printouts remain in the output tray, remove them.
3
Set the power switch to "O".
The following are cleared.
G
Settings that are not programmed, such as the number of copies
G
Data scanned using the "Scan to Memory" function
G
Jobs queued to be printed
G
Jobs saved with the "Memory Recall" function
Stored zoom ratios, programmed Copy mode settings, Utility mode
settings and UserBox settings are not erased.
Note
Do not turn off the copier while it is making copies or printing, other-
wise a paper misfeed may occur.
Do not turn off the copier while it is scanning or sending or receiving
data, otherwise all scanned data or transmission data will be deleted.
Do not turn off the copier while a queued job or stored data is waiting
to be printed, otherwise the jobs will be deleted.
CF2002/CF3102
3
3-39