Stapling (With Finisher Fn-8 Installed); Hole-Punching - Minolta CF 2002 Advanced Information

7

Stapling (with finisher FN-8 installed)

The copies are bound together with a staple. Either the "Corner Staple" or
the "2-Point Staple" Finishing setting can be selected.
However, stapling is only performed if the following conditions are met.
G The number of copies is set to between 2 and 50. (However, if the
paper length is 300 mm or more, the number of copies can only be set
to 25 or less.)
G If standard-size paper is used, the paper sizes must be A3 L, A4 L and
A4 C.
G
If nonstandard-size paper is used, the paper width must be between
182 mm and 297 mm.
G
If nonstandard-size paper is used, the paper length must be between
182 mm and 432 mm.
G The copier must not enter Interrupt mode.

Hole-Punching

Two holes for filing copies in binders can be punched. The position of the
punched holes can be specified along the left side or along the top.
However, hole-punching is only performed if the following conditions are
met.
G
Finisher FN-8 is installed.
G
Punch kit PK-4 is installed.
G
If standard-size paper is used, the paper sizes must be A3 L and A4 C.
G If nonstandard-size paper is used, the paper width must be between
182 mm and 297 mm.
G If nonstandard-size paper is used, the paper length must be between
182 mm and 432 mm.
G The copier must not enter Interrupt mode.
7-16
Advanced Operations
CF2002/CF3102