Table of Contents
Advertisement
11
11.11 Other Messages
Message
Original left on the Glass.
Matching paper size is not
available.
Reselect the paper size.
Original's size cannot be
detected.
Reselect the paper size.
This mode cannot be
selected with the XXXXXX.
The Exit Tray has reached its
capacity.
Please input your 4-digit
Access# and press the
Access key.
Your account has reached its
maximum allowance.
Section -> is open.
Close it properly.
Please insert the Fusing Unit
and close all doors.
Install the CF toner cartridge,
and then move the lever to
the correct position.
Please insert the Waste
Toner Bottle and close all
doors.
Please insert the Image
Transfer Belt Unit and close
all doors.
Replenish paper.
11-50
Cause
The document was left on
the original glass.
Paper of a suitable size is not
loaded in a paper drawer.
(1) The document is not
positioned correctly.
(2) A document with an
unspecified size or with a
size too small to be detected
is loaded.
Functions that cannot be
used together are selected.
Since the maximum amount
of copies for the indicated
finisher output tray has been
exceeded, the copier is
unable to make copies.
Access codes have been
specified. Copies cannot be
made unless a specified
access code is entered.
The limit on the number of
copies that can be made has
been reached.
Since a copier door or cover
is open or an option is not
installed correctly, the copier
is unable to make copies.
The fusing unit is not
installed correctly.
The indicated toner cartridge
is not installed correctly.
The waste-toner bottle is not
installed correctly.
The image transfer belt unit
is not installed correctly.
The indicated drawer has ran
out of paper.
Touch Panel Messages
Remedy
Remove the document from
the original glass.
Either select a different copy
size or manually feed paper
of a suitable size.
(1) Position the document
correctly.
(2) Select the correct paper
size.
Make copies using only one
of the functions.
Remove all copies from the
indicated tray.
Enter your access code.
(p. 3-38)
Contact your technical
representative.
Make sure that all doors and
covers are closed and that all
options are installed
correctly.
Reinstall the supplies or
parts, or contact your
technical representative.
Load paper into the indicated
drawer.
(See "Loading Paper" on
page 4-1.
CF2002/CF3102
Advertisement
Table of Contents
