The Copier Is Not Functioning As Designed; The Touch Panel Shows Nothing; No Copies Are Fed Out When The Start Key Is Pressed; Control Panel Keys Do Not Respond - Minolta EP3050 Operator's Manual

2. The Copier is not functioning as designed

Symptom

The Touch Panel shows nothing.

No copies are fed out when the
Start Key is pressed.
Control Panel Keys do not respond. The Interrupt Key LED is lit up.
The copier is not activated when
the Power Switch is turned ON.
If these procedures do not correct the problem, contact your Technical Representative.
check for:
Is only the Start Key lit up green?
The Display Contrast Control
Knob is placed in the excessively
light or dark position.
The copier was just turned ON and
is warming up.
The copier has developed a
malfunction.
The power cord is left unplugged
from the power outlet.
The room circuit breaker is open.
Action
The copier is in the Energy Saver
Mode.
Press any key on the Control Panel
to cancel the Energy Saver Mode.
p. 26
Viewing the Touch Panel, turn the
Display Contrast Control Knob as
necessary. p. 19
It takes the copier about 2 minutes
and 30 seconds to be ready for
making copies after it has been
turned ON.
Please wait.
Check the Touch Panel and take
action according to the message on
the Panel. p. 158
The copier is in the interrupt mode.
Press the Interrupt Key to cancel
the interrupt mode. p. 38
Plug the power cord into the power
outlet.
Close the room circuit breaker.
165