Table of Contents
Advertisement
Troubleshooting
12.2
When the Copier Is Not Operating Correctly
Symptom
Nothing appears on the touch
panel.
The indicator on the [Start] key
does not light up in green.
Even though the [Start] key is
pressed, no copies are made
Keys on the control panel do
not respond.
The copier cannot be turned
on.
CF2002/CF3102
Possible Cause
If only the indicator on the
[Start] key is lit, the copier is
in Energy Saver mode.
The contrast control knob
for the touch panel has
been set either too light or
too dark.
The scanner power cord or
the interface cable are
disconnected.
An access code has not
been entered.
The copy/print job is
queued for printing.
The copier is still warming
up after just being turned
on.
The copier is
malfunctioning
If the indicator on the
[Interrupt] key is lit, the
copier is in Interrupt mode.
The power supply cord may
have been unplugged from
the electrical outlet.
The room's circuit breaker
was tripped.
12
Remedy
Press any key to cancel
Energy Saver mode.
(See p. 3-31)
While looking at the touch
panel, adjust the contrast
control knob.
(See p. 3-26)
Set the power switch for the
copier to "O", and then re-
connect the scanner power
cord and the interface
cable.
Enter the access code.
(See p. 3-38)
Touch [Job Log] to check
the jobs that are queued.
Wait until printing begins.
The copier takes about 5
minutes to warm up after it
is turned on.
Wait until the copier has
finished warming up.
Follow any messages that
appear on the touch panel.
Press the Interrupt key to
cancel the mode.
(See p. 3-33)
Plug the power supply cord
into an electrical outlet.
Close the room's circuit
breaker.
12-3
Advertisement
Table of Contents
