Triggers," Starting On; To Copy Search Setups; Navigating The Time Base - Agilent Technologies InfiniiVision 3000 User Manual

2
Horizontal Controls
Remember that searches use the measurement threshold settings instead
of trigger levels. Use the Thresholds softkey in the Search Menu to access
the Measurement Threshold Menu. See
page 234.

To copy search setups

Except for Serial event search setups, you can copy search setups to
trigger setups and vice- versa.
1 Press [Search].
2 In the Search Menu, press Search; then, turn the Entry knob to select
3 Press Copy.
4 In the Search Copy Menu:

Navigating the Time Base

You can use the [Navigate] key and controls to navigate through:
58
• For setting up Pulse Width searches, see
page 147.
• For setting up Rise/Fall Time searches, see
Trigger" on page 155.
• For setting up Runt searches, see
• For setting up Serial searches, see
page 141 and "Searching Lister Data"
the search type.
Press Copy to Trigger to copy the setup for the selected search type to
•
the same trigger type. For example, if the current search type is
Pulse Width, pressing Copy to Trigger copies the search settings to the
Pulse Width trigger settings and selects the Pulse Width trigger.
Press Copy from Trigger to copy the trigger setup for the selected search
•
type to the search setup.
To undo a copy, press Undo Copy.
•
The softkeys in the Search Copy Menu may not be available when one
of the settings cannot be copied or there is no trigger type that
corresponds to the search type.
"Runt Trigger"
Chapter
"Measurement Thresholds"
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
"Pulse Width Trigger"
"Rise/Fall Time
on page 158.

10, "Triggers," starting on

on page 126.
on
on