Connect Probes To The Oscilloscope; Maximum Input Voltage At Analog Inputs - Agilent Technologies InfiniiVision 3000 User Manual

1
Getting Started
2 The oscilloscope automatically adjusts for input line voltages in the
Always use a grounded power cord. Do not defeat the power cord ground.
WA R N I N G
3 Press the power switch.
The power switch is located on the lower left corner of the front panel.
The oscilloscope will perform a self- test and will be operational in a few
seconds.

Connect Probes to the Oscilloscope

1 Connect the oscilloscope probe to an oscilloscope channel BNC
2 Connect the probe's retractable hook tip to the point of interest on the
C A U T I O N
CAT I 300 Vrms, 400 Vpk; transient overvoltage 1.6 kVpk
50 input: 5 Vrms Input protection is enabled in 50
disconnect if greater than 5 Vrms is detected. However the inputs could still be
damaged, depending on the time constant of the signal. The 50
functions when the oscilloscope is powered on.
With 10073C 10:1 probe: CAT I 500 Vpk, CAT II 400 Vpk
With N2862A or N2863A 10:1 probe: 300 Vrms
28
range 100 to 240 VAC. The line cord provided is matched to the country
of origin.
connector.
circuit or device under test. Be sure to connect the probe ground lead
to a ground point on the circuit.

Maximum input voltage at analog inputs

Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
mode and the 50 load will
input protection only