Flexray Serial Decode - Agilent Technologies InfiniiVision 3000 User Manual

2 In the Trigger Menu, press the Trigger softkey; then, turn the Entry knob
3 Press the Trigger softkey; then, turn the Entry knob to select Event.
4 Press the Event softkey; then, select the event type:
5 Press Auto Setup for Event.

FlexRay Serial Decode

To set up the oscilloscope to capture FlexRay signals, see
FlexRay Signals"
For FlexRay triggering setup see
N O T E
To set up FlexRay serial decode:
1 Press [Serial] to display the Serial Decode Menu.
2 If the decode line does not appear on the display, press the [Serial] key
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
to select the serial bus (Serial 1 or Serial 2) on which the FlexRay
signals are being decoded.
Wake-up
•
TSS — Transmission Start Sequence.
•
BSS — ByteStart Sequence.
•
FES/DTS — Frame End or Dynamic Trailing Sequence.
•
This automatically configures oscilloscope settings (as shown on the
display) for the selected event trigger.
on page 351.
to turn it on.
FlexRay Triggering and Serial Decode
"FlexRay Triggering" on page 352.
23
"Setup for
355