Vertical Controls," Starting On - Agilent Technologies InfiniiVision 3000 User Manual

16.
17.
18.
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
Vertical The Vertical controls consist of:
controls • Analog channel on/off keys — Use these keys to switch a channel on
or off, or to access a channel's menu in the softkeys. There is one
channel on/off key for each analog channel.
• Vertical scale knob — There are knobs marked
channel. Use these knobs to change the vertical sensitivity (gain) of
each analog channel.
• Vertical position knobs — Use these knobs to change a channel's
vertical position on the display. There is one Vertical Position control
for each analog channel.
• [Label] key — Press this key to access the Label Menu, which lets
you enter labels to identify each trace on the oscilloscope display. See
Chapter
For more information, see
page 61.
Analog channel Attach oscilloscope probes or BNC cables to these BNC connectors.
inputs With the InfiniiVision 3000 X-Series oscilloscopes, you can set the input
impedance of the analog channels to either 50
specify channel input impedance"
The InfiniiVision 3000 X-Series oscilloscopes also provide the AutoProbe
interface. The AutoProbe interface uses a series of contacts directly
below the channel's BNC connector to transfer information between the
oscilloscope and the probe. When you connect a compatible probe to the
oscilloscope, the AutoProbe interface determines the type of probe and
sets the oscilloscope's parameters (units, offset, attenuation, coupling,
and impedance) accordingly.
Demo 2, • Demo 2 terminal — This terminal outputs the Probe Comp signal
Ground, and which helps you match a probe's input capacitance to the
Demo 1 oscilloscope channel to which it is connected. See
terminals Passive Probes"
oscilloscope can also output demo or training signals on this terminal.
• Ground terminal — Use the ground terminal for oscilloscope probes
connected to the Demo 1 or Demo 2 terminals.
• Demo 1 terminal — With certain licensed features, the oscilloscope
can output demo or training signals on this terminal.
9, "Labels," starting on page 135.
Chapter

3, "Vertical Controls," starting on

on page 64.
on page 32. With certain licensed features, the
1
Getting Started
for each
or 1 M . See "To
"Compensate
39