To Display A Reference Waveform - Agilent Technologies InfiniiVision 3000 User Manual

5
Reference Waveforms
2 In the Reference Waveform Menu, press the Ref softkey and turn the
3 Press the Source softkey and turn the Entry knob to select the source
4 Press the Save to R1/R2 softkey to save the waveform to the reference
Reference waveforms are non-volatile — they remain after power cycling or performing a
N O T E
default setup.
To clear a 1 Press the [Ref] key to turn on reference waveforms.
reference
2 In the Reference Waveform Menu, press the Ref softkey and turn the
waveform
location
3 Press the Clear R1/R2 softkey to clear the reference waveform location.
Reference waveforms are also cleared by a Factory Default or Secure
Erase (see
page 263).

To display a reference waveform

1 Press the [Ref] key to turn on reference waveforms.
2 In the Reference Waveform Menu, press the Ref softkey and turn the
3 Then, press the Ref softkey again to enable/disable the reference
100
Entry knob to select the desired reference waveform location.
waveform.
waveform location.
Entry knob to select the desired reference waveform location.
Chapter 17, "Save/Recall (Setups, Screens, Data)," starting on
Entry knob to select the desired reference waveform location.
waveform display.
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide